Hands-on Training

• [4.0 hr] Lab Training
  • Factory Reset
  • Network Configuration
  • Faceplate Functionallity
  • Programmable Control
    • Configure IO Tree
    • Local Tag Modification
    • Subroutine Development
    • Functional Testing Using Wired Control Station
  • Parameter Configuration

Prerequisites

• [8.0 hr] Online Training Portal – Introduction to Networking
• [16.0 hr] Online Training Portal – PLC Basics
• [2.0 hr] Online Training Portal – Powerflex 525

Skillset Development

• LOTO
• Jogging motor & adjust speed from faceplate
• STO Safety wiring (S+/S1/S2 pins)
• I/O pin configuration (1/11 pins)
• Factory resetting
• Configure Network - Faceplate
• Configure Network - BootP
• Network troubleshooting
• Adding drive to RSLinx Classic & FactoryTalk Linx Browser
• Adding drive to Studio 5000 project
• Setting drive parameters
• Motion control through drive tags
• Motion control through ladder logic routine
• Motion concepts
  • Start/Stop
  • Direction
  • Speed (frequency)
  • Acceleration & Deceleration

Examination

• [1.5 hr] Hands-on Demonstration
• [0.5 hr] Written Exam